We provide commercial roof repair services in Indianapolis for flat membranes, metal panels, hidden leaks, and plant roofs.
Our commercial roof repair services in Indianapolis split by roof type and by what you see. Start with the card closest to your problem.
Flat roof repair covers single-ply and asphalt membranes on offices, retail blocks, and warehouses, from one split seam to a wet section.
Typical Repairs
Fasteners, side laps, end laps, trim, skylight panels, and panels rusted through on steel buildings all fall under this service.
Typical Repairs
Commercial roof leak repair is for owners who know where water shows inside but not where it enters on any roof system.
Typical Repairs
Industrial roof repair suits manufacturing plants and process buildings where grease, vibration, and foot traffic wear the roof unevenly.
Typical RepairsMembrane roofs and metal roofs fail in different places, so they get different repairs. Here is how the two compare.
TPO, EPDM, PVC, modified bitumen, and built-up roofs.
Exposed-fastener and standing-seam steel roofs.
Describe what you see inside and on the roof. The roof walk settles which service fits, and the estimate follows.
Schedule Your Free InspectionWhichever service fits, the visit follows the same five steps.
Your description of the stain, drip, or damage decides where the walk begins and what material comes along.
The ceiling or deck below the problem gets checked first, then the roof area above it.
Once the source is clear, you hear which repair it needs and why, with photos of the damage.
The scope and price come in writing before work starts, including any wet insulation to replace.
The repair gets done to match the roof, and the photos and notes go to you after.
How the four services differ and how to choose between them.
Start with what you see. Water inside with no obvious cause fits leak repair. Ponding, lifted seams, or a bad drain on a low-slope roof fits flat roof repair. Loose screws, rust, or drips along panel ribs fit metal roof repair. Damage around fans, stacks, and walk paths on a plant fits industrial roof repair.
Yes. Many buildings have a flat roof over the offices and metal over the warehouse, or a plant roof with an office wing. One inspection covers every roof area on the building, and the estimate lists each repair separately so you can schedule them in the order you choose.
TPO, EPDM, PVC, modified bitumen, and built-up membranes, plus exposed-fastener and standing-seam metal. Each repair uses material that matches the roof it goes on, which keeps seams and laps sealing properly and avoids mixing products that do not bond to each other.
We do. When a full repair needs dry or warmer weather, or materials have to be ordered, a temporary seal or cover goes over the source first. The permanent repair follows on a workable day, and both steps show up on the estimate.
Dated photos of the damage before work, the repair in progress, and the finished repair, plus a short note on anything else we saw. Owners use the file for maintenance planning, lease discussions with tenants, and insurance questions.
When moisture readings show wet insulation across large areas, or when seams and panels are failing faster than repairs can keep up. At that point we tell you so, list the temporary repairs that keep the building dry, and you decide how to plan the larger project.
Our work is commercial only: offices, retail, warehouses, plants, churches, schools, and other commercial buildings in Indianapolis and five nearby towns. Homeowners need a residential roofer, since house roofs use shingle systems, ladders, and permits that differ from the membrane and metal roofs we repair every week.
Tell us what you see and where the building is. We inspect the roof and match the repair to it.